Strike Industries Aluminum Extended Magazine Plate for GLOCK™ G19 (9mm)

The Strike Industries Aluminum Extended Magazine Plate for the GLOCK™ G19 (9mm) is engineered to facilitate smooth magazine reloads with a slow-draw/no-hook design while maintaining maximum magazine capacity. Constructed of 6061-T6 aluminum , this Extended Magazine Plate (EMP) adds an additional five 9mm rounds to the GLOCK™ G19's OEM double-stack magazines.

Product features:

• Made of 6061-T6 aluminum
• Plus 5 round capacity for 9mm
• Including aluminum locking plate
• Low pull / no hook design
• Fits USPSA 140mm racing class limit
• Available in anodized SI BLACKLINE, REDLINE or FDELINE colors

Compatibility:

• GLOCK™ OEM G19 (9mm) double stack magazines
• SI EMP Pocket Clip
• Magwell: tested with SI Magwells

Not compatible:

• G23 (.40 Cal)
• 10-round magazines
• ETS Magazine

Note: Not for sale to residents of California, Hawaii, New York, and New Jersey due to 10-round laws. The checkout process does NOT display an available shipping method. It is the customer's responsibility to inform themselves about and comply with local gun laws.

Caution: DO NOT TIGHTEN THE SEAL WASHER SCREW when installing the aluminum safety plate. If unsure, please contact our customer service team or consult your local gunsmith.

The SI Aluminum EMP was intentionally designed to be a tight fit and may damage the polymer magazine base ears. Must be installed only by a certified gunsmith. Use a small C-clamp (or similar tool) to gently and lightly compress the bottom center of the magazine base just above the plastic safety ears where the SI Aluminum EMP attaches to the magazine. Just enough to allow the SI Aluminum EMP to slide in or out. Be careful not to bend the OEM magazine metal and remove the C-clamp (or similar tool) immediately once the SI Aluminum EMP is installed or removed. The C-clamp or similar tool may scratch the surface of the magazine base. Please be careful and use a material to protect the surface of the magazine base.